Dyno Numbers in from LAPD's SuperCharged H2 !! [Archive] - Hummer H2 Forum: H2 forums

Dyno Numbers in from LAPD's SuperCharged H2 !!

L.A.P.D.
06-12-2004, 07:54 PM
All H2 Fanatics,

I am thrilled to report the initial results of our H2 project and they are astounding ...500 HP and 557 Foot Lbs Torque @ the flywheel.




- click on the link below -

H2 4WD Dyno Results (http://img.villagephotos.com/p/2003-3/128268/lapdHummer.JPG)

RedGTS
06-15-2004, 07:56 PM
What other mods does it have, and what boost level? BTW, that's a pretty serious driveline loss you're using (25%). Is that based on stock dyno numbers v. the factory hp/tq ratings, or what?

Submariner
06-22-2004, 05:00 AM
LAPD,

What are the SAE corrected wheel numbers? The graph doesn't mention any correction factor whatsoever. I'm also assuming this was a Magnussen kit?

Thanks,

Cory

L.A.P.D.
06-23-2004, 10:00 AM
What other mods does it have, and what boost level? BTW, that's a pretty serious driveline loss you're using (25%). Is that based on stock dyno numbers v. the factory hp/tq ratings, or what?

I based the driveline losses on dyno runs on several stockers, including ours.


Thanks,

Shawn

L.A.P.D.
06-23-2004, 10:03 AM
LAPD,

What are the SAE corrected wheel numbers? The graph doesn't mention any correction factor whatsoever. I'm also assuming this was a Magnussen kit?

Thanks,

Cory

Cory,

The upper right hand corner of the dyno graph shows it is SAE and the correction factor, not listed, was 1.02.

Thanks,

Shawn

Submariner
06-24-2004, 06:19 AM
Thanks for the additional info. Sorry I missed the SAE note on top.

Cory